Ungluing a Ship part

[Anthony53]

Can this be unglued and reset as it set at an angle ? Any ideas would be most welcome. Oh this is my first ever Ship build on a Occre Polaris 1:50 scale as you can tell I'm a newbie LOL .I thought these clips would help the bulk heads if that's what they're called set on the keel as they are supposed to.

 

[Zzyzx01]

You might want to use Acetone (or nail polish remover) to help soften the glue. Dab it on using a Q-tip or brush. Don't be afraid to wet the joint. Wait a few minutes as the acetone gasses off very quickly. Use an X-acto to help loosen. You will probably need to repeat several times, but be patient and work slowly until it releases.
Hope this helps.
...henry

 

[Kurt Konrath]

What type of glue did you use?

A common tip to help keep bulkheads square, use LEGO blocks, what lego folks call 2x4 about an inch long and half inch wide, can be clipped to keel to keep in alignment.