Brass keel mounts

[Sapper]

I am looking ahead (a couple of years at my present build rate!) to prepare for how to display my Caldercraft HMS Victory. I have thickened the keel internally in two places to facilitate drilling bolt-holes through the keel to take future fixings. I see photos of a number of completed models that are supported by brass cylindrical mounts fixed to their keels fore and aft. Can anyone point me in the direction of where to buy these? Does anyone have an opinion as to their adequacy, or should I add lateral support amidships also?

 

[AllanKP69]

Scroll down on the page below

Display Bases, Stands & Columns

A selection of Display Base for Model Boats and Ships. The range also includes mounting columns and display stands.

www.cornwallmodelboats.co.uk

Allan

 

[Sapper]

Thanks for the link.

 

[AllanKP69]

Glad to help.
Allan

 

[Jerome]

It can be kind of tricky to get a good secured hull on just pedestals.
You may get lucky and have great success.
But you may end up adding a couple of small “steadying mounts” either side of the hull.
On one hull I used bare copper rod of small diameter to support the hull.
I just drilled a hole through the base board and slightly rolled the end against the hull over a little.
Worked fine and wasn’t actually attached to the hull.

 

[Sapper]

It can be kind of tricky to get a good secured hull on just pedestals.
You may get lucky and have great success.
But you may end up adding a couple of small “steadying mounts” either side of the hull.
On one hull I used bare copper rod of small diameter to support the hull.
I just drilled a hole through the base board and slightly rolled the end against the hull over a little.
Worked fine and wasn’t actually attached to the hull.

Useful information. Thanks. Something to design as a break from rigging in due course.