Etoile 1:50 - Billing Boats Build log

[ARU01]

As per suggestion i had posted some of it in the forum under wrong heading. wil start again here with the build of the Etoile from Billing Boats

 

[ARU01]

I already posted some pictures in wrong Forum. so starting again as model nears completion.
Do not know about you all . but this model which i started some 12 years ago and only had hull finished.
Retired now and time to spare.
Finaly found out that it is essential to do all the masting and running rigging and sails before putting on ths shrouds and fixxed rigging . Would have also be easier to do all the rigging before filling deck with cabins etc.

 

[ARU01]

Biggest problem was deciphering the drawings. the rigging was on both sides of same A1 drawing, so need to turn over this big sheet of paper is nightmare.
Also some rigging could not be placed (blocks) due to lack of access with deck already populated. so had to skip a block here and there on the deck.
I think no one will notice.
Had to be very creative with blocks as these where missing from the kit when i got it second hand.
The anchor chain winch was made from scratch. (this belonged to separate kit accessory pack which is no longer available)
As i cannot buy anything on my small island had ordered blocks (5mm) and Pins per billing boat number, which are way too short to do normal loop. so inserted threads true the holes and secured it with the pin.
Once i place the rope hanks it will look natural.

Trying to figure out how to attach the ratlines which are tiny wooden strips to the shrouds.
any suggestions welcome

 

[Frank48]

I already posted some pictures in wrong Forum. so starting again as model nears completion.
Do not know about you all . but this model which i started some 12 years ago and only had hull finished.
Retired now and time to spare.
Finaly found out that it is essential to do all the masting and running rigging and sails before putting on ths shrouds and fixxed rigging . Would have also be easier to do all the rigging before filling deck with cabins etc.View attachment 602863View attachment 602864View attachment 602865View attachment 602866View attachment 602867View attachment 602868View attachment 602869View attachment 602870View attachment 602871View attachment 602872View attachment 602873View attachment 602874View attachment 602875View attachment 602876View attachment 602877View attachment 602878View attachment 602879View attachment 602880

View attachment 602881

View attachment 602882

View attachment 602883

View attachment 602884

View attachment 602885

View attachment 602886

Hi ARU01, may I point out that the pulleys are installed incorrectly? You should rotate them 180 degrees (so the holes face the lugs). Frank