Finally Ready to start - USS Enterprise in 1/350

[Davidp]

take a look at this link https://www.navsource.org/archives/02/65b.htm in respect to the stern area of your model especially the cwis platform on the port stern.

 

[Viper]

take a look at this link https://www.navsource.org/archives/02/65b.htm in respect to the stern area of your model especially the cwis platform on the port stern.

Ok I see that there are no life rafts at that location. That's what the kit directions had, makes sense not to have them located there. will remove them. lol, I was stationed on the Detroit so about the only time I got to see them was coming along side to replenish.

 

[Beau]

Happy Easter everyone,
I have been working on painting the safety lines around the elevators on my 1/350 USS Enterprise CVN 65.
Apart from a few small corrections that need to be done, they have come out quite well.
I will be respraying the grey on the deck after all the detailing is finished.
Beau.

 

[Viper]

Happy Easter everyone,
I have been working on painting the safety lines around the elevators on my 1/350 USS Enterprise CVN 65.
Apart from a few small corrections that need to be done, they have come out quite well.
I will be respraying the grey on the deck after all the detailing is finished.
Beau

looking good

 

[Viper]

Well I know its been a bit since I've posted any progress. I ran into a bit of a snafu with my air brush paints. Apparently they got to cold last winter and are gelling up. So I decided I would do the unthinkable and hand paint the flight deck..........bad mistake! Did so research and found out how to strip that off and bought so spray paint to redo the flight deck. Also been doing some detail painting of the same . Photo Attached