-
SUBSCRIBE TO SHIPS IN SCALE TODAY!
The beloved Ships in Scale Magazine is back and charting a new course for 2026!
Discover new skills, new techniques, and new inspirations in every issue.
NOTE THAT OUR NEXT ISSUE WILL BE MARCH/APRIL 2026 -
Win a Free Custom Engraved Brass Coin!!!
As a way to introduce our brass coins to the community, we will raffle off a free coin during the month of August. Follow link ABOVE for instructions for entering.
USS Constitution 1:96 - Revell Build Log...
- Thread starter Greysteele
- Start date
- Watchers 18
-
- Tags
- constitution revell
- Joined
- Sep 18, 2022
- Messages
- 253
- Points
- 138
- Joined
- Jan 30, 2026
- Messages
- 12
- Points
- 28
Jupp. Heller Victory..next to come...
Ahoy! The prodigal shipbuilder has returned. I won't bore you with the particulars that dragged me away from Connie these last few years (anyone else take up bizarre hobbies like blacksmithing in their retirement?), but I am back on the job.
I'm ready to close up the gun deck on my Constitution as soon as the 15-minute epoxy I ordered arrives Tuesday. I've spent a good bit of time fine-tuning the knees and beams that will support the spar deck at the right height. I made some cannonball racks and stained some 2mm brass bearings for the cannonballs. So much of this level will never be seen again so I'm ready to move on.
I'm ready to close up the gun deck on my Constitution as soon as the 15-minute epoxy I ordered arrives Tuesday. I've spent a good bit of time fine-tuning the knees and beams that will support the spar deck at the right height. I made some cannonball racks and stained some 2mm brass bearings for the cannonballs. So much of this level will never be seen again so I'm ready to move on.
Lookin good!!
Have you glued together the 3 sections of spar deck as others have done before fitting it to the hull? I'm just about ready to add the spar deck, but can't figure out how to squeeze the whole spar deck onto the hull without breaking things. Waiting to see what you do!
Have you glued together the 3 sections of spar deck as others have done before fitting it to the hull? I'm just about ready to add the spar deck, but can't figure out how to squeeze the whole spar deck onto the hull without breaking things. Waiting to see what you do!
The spar deck is assembled and ready to rock. I've spent a lot of time making it fit as close to the edges as possible. The cross beam supports are doing some of the work of establishing the gap so the spar deck pretty much drops in with little adjustment. It goes in far easier than the gun deck did. That one was a bear to install and required a lot of tense moments, spreading the hull and praying it wouldn't crack or separate. There are a couple of places in the middle where I couldn't install beams that are a little tight or loose. The tight spots will require a tiny bit of spread for the spar deck to fit in. The loose spots will call for some clamping to pull things together. I have some small bar clamps that will likely work. I've also seen other builders use tape and/or string to pull things tight. Hopefully all my planning won't go to hell too badly when the glue goes down. I got slow-setting epoxy so I'd have time to make adjustments during that critical phase. Fingers crossed.
You make it look easy!! 