Vanda-Lay Duplicator someone?

Joined
Jul 9, 2016
Messages
1,475
Points
443

Location
Mount Martha, Victoria Australia
Hi Janos,
I just spoke to a friend who purchased it, and he reckons its not a sturdy unit. Theses too much play and shake to the unit for those fine details.
I would be most grateful if you could post up a photo of your unit please ?
 
Joined
Jul 2, 2013
Messages
778
Points
343

Location
Sydney
I've got one Vanda-Lay milling table for Dremel, better than the D but not really sturdy and difficult to adjust.
I published a few pictures about my self made one in a different thread a while ago, I just have to find it and will give you a link somewhat later, because I am out at the moment.
János
 
Joined
Jul 2, 2013
Messages
778
Points
343

Location
Sydney
Hi Brian,
Here is the link:
And there is another link in this thread for further info.
János
 
Top