Model VICTORY by Deagostini, scale 1/84 [COMPLETED BUILD]

[GrantTyler]

Canifas blocks for pertuline anchors
View attachment 376758View attachment 376759View attachment 376760View attachment 376761
But in these photos, a comparison of the canifade block from Anatomy, the magazine version and the one I made
View attachment 376762View attachment 376763
I think I got something similar to the version from Anatomy

Good morning Sasha. No words….just incredible. Cheers Grant

 

[Alexander74]

Friends, hello everyone. Did some work at the shipyard. Small stages in the photo

 

[Nomad]

Nice, clean and crisp!

 

[NOVICHOK]

Добрая работа.где бы мне получить толику вашей аккуратности)))

 

[Alexander74]

Добрая работа.где бы мне получить толику вашей аккуратности)))

Desire, patience and are not afraid to correct their mistakes.

 

[dockattner]

Always a delight to see your work Sasha! The close-up on the decking and trenails is superb!

 

[Alexander74]

Always a delight to see your work Sasha! The close-up on the decking and trenails is superb!

Pavel, thanks.
Even better after oiling

 

[Alexander74]

Hello friends. Thanks for the comments and likes. Work with small elements continues.
Before making ladders on the forecastle deck, it was necessary to install 2 guns and tie them, blocks 2.5 mm, thread 0.3 mm

 

[Alexander74]

Then I made ladders to the upper deck, until they are glued

 

[Alexander74]

Well, also different bitings, small work

 

[Nomad]

Nice work as always Sasha

 

[Dean62]

Nice touch with the accents on the sides of the ladders.

 

[Alexander74]

Good afternoon friends. Fine detail work continues. He made cruys, coffee-pin strips and the coffee-pins themselves. They are from a magazine, I just processed them with a file and sandpaper and blackened them.

 

[Alexander74]

Installed ladders. The steps themselves were cut out on the CNC by my colleague. I had only to fit each step to the side, because they should be horizontal to the water. Then I stained it with yellow stain and black permanent marker.

 

[Nomad]

Brilliant!

 

[GrantTyler]

Installed ladders. The steps themselves were cut out on the CNC by my colleague. I had only to fit each step to the side, because they should be horizontal to the water. Then I stained it with yellow stain and black permanent marker.
View attachment 380300View attachment 380301View attachment 380302View attachment 380303

No Way!! Sasha this is a legendary Victory. Good evening Sasha. I don’t think guys realise the complexity of this ship especially when it it constructed as you have done. Brilliant Sasha. Cheers Grant

 

[WojtasS]

Hi Sacha. Your present building moment is getting more and more interesting. Steps and ladders look fantastic.
Only rigging of this cannon looks weird was it you decision or customer? Actually not the rigging itself, but eylets of single blocks seem not int the best position

 

[Alexander74]

Hi Sacha. Your present building moment is getting more and more interesting. Steps and ladders look fantastic.
Only rigging of this cannon looks weird was it you decision or customer? Actually not the rigging itself, but eylets of single blocks seem not int the best position

View attachment 380404

Wojtas, thank you. Here is the harness at the installation stage, after the photo I also noticed that the butt got out of the tool machine. I have corrected.

 

[DARIVS ARCHITECTVS]

I love your work, Sasha.

 

[Alexander74]

Hi all. Thanks for your support and comments. Made stern cut-beams and decorative drift rails