ModelShipways Norwegian Sailing Pram In Progress

Ok, after all my ranting, everything turned out well. The rear stern sheet sits on the ledge between the two transom parts and the stern transom knee. The other part of the stern sheet is sanded and fits snug between the sheer strakes. I removed the two stern thwart knees and will replace them so they reach higher and add support to that sheet. The thwart that partially surrounds the daggerboard case needed the most sanding to fit. I had done this earlier before I relocated the daggerboard case and ended up cutting too much off. I added a piece of scrap to the end of it and now have it sanded to fit correctly. The forward thwart needed the least sanding but needed the two notches deepened. I used my dremel scroll saw to make a series of cuts into each notch and then my #11 blade to clean up the notch. I am now happy with the results.



Now to move on to the floor boards.

The hull has been primed and is now drying. I will next sand it and paint it. While I am waiting to paint, I have been working on the tiller and re-reading the next steps. This is where I feel the instructions are very confusing.

I have joined the three tiller parts and installed the pin in them. I don't have small hammer so I grasped the pin in the jaws of needle nose pliers and hit it with hammer. I think that served the same purpose. Question is, am I supposed to use same 1/16 wire for the tiller extension? Seems extension is too narrow and will split.

Next I started looking at installing the various hardware pieces. I found it confusing as to which photo etched brass pieces were what. So I took a picture and then went through directions and labeled them as I see them. Here is the picture. Do I have these correct?
.
Thanks for looking.

I believe you have those correct. I found that most of the holes were too small for the parts and nails and had to be enlarged. A few of the items like the oar locks I just glued into place using CA.

Rob

The Pram has been painted and I have started installing hardware. I installed the stay plate on the bow transom. I used a Dremel cutoff wheel to cut the brass tube to simulate the hex nut. Much easier using Dremel for this. For the two stay plates on the side, I merely glued them in the slots using CA. What is the best way to open up the holes in the photo etched parts to accept the brass nails? I got tired of messing with those little pieces that I would switch to working on the mast. I glued the two halves of the square mast and started assembling the spar shaping jig. Of course like everyone else there is a fifth notched piece that is missing. I will try to make one from the scrap wood. Did others do this or just omit one and if so which hole did you leave empty?

Here are pictures of the painted hull.