• Win a Free Custom Engraved Brass Coin!!!
    As a way to introduce our brass coins to the community, we will raffle off a free coin during the month of August. Follow link ABOVE for instructions for entering.

Model of classic RuneScape king black dragon - piñata

DerezzedDragon said:
View attachment 550040
Got one foot left then I can get to thickening. Picked up a can of spray paint to help the crepe paper go farther.
View attachment 550041View attachment 550042
Decided to leave the gaps as it's just going to be covered
View attachment 550043
Only problem is a put the dew claw on the same side. Any suggestions for cutting it off and swapping sides? I have a foam cutter thingy kit to get through the hot glue maybe but not sure if it would ruin it / how to clean it..
Click to expand...
Amazing work, DD. Could you simply swap the legs without cutting anything? If you must cut the claws off, then a sharp knife should be adequate for cutting through hot melt glue. Multiple shallow passes should get you through cleanly.
 
Looking great ! I agree with Namabiiru. Just make multiple passes with your knife. Don't apply a lot of pressure and you should be able to remove it.
If you have to remove the glue, you can use the tip of the glue gun and don't dispense any glue. The heat will re-melt the glue.
 
You must log in or register to reply here.
Back
Top