I was looking through one of the model ship building catalogs when I came across a wire bending jig. After looking at it a few minutes my thoughts ran to whether or not I could use my 3D printer to make one. So off to the Google and sure enough I found the file for one on Thingiverse. They called it simply a Wire Jig. I downloaded it and later printed it. After I looked at it for awhile my thoughts were that I possibly needed one smaller for ship model work. Therefore, I scaled it down by 50% and printed a smaller one. The results are as shown. I plan to add a couple of pins in different sizes that I can use to make eyebolts and to add pins that I can use to make hooks. I'll just drill the jig and add the pins. Right now I using a piece of scrap wood for the pins.