Looking good Kurt.
Just a bit of advice: try to remove the excess glue as you go along inside and out.
For the outside, You can either wipe it off right away or wait a bit until it sets, and scrape / cut it off with a sharp blade. Personally, I wipe it off if there is just a little bit: if there is a lot I wait a few minutes and run a blade to take it away before it is completely dry, this way it come right off without spreading it further.
For the inside, run your finger along the joint to avoid ending up with large drops or runs: these may be a pain to sand off: they are with the glue I use.
To avoid excess glue oozing in the inside, I concentrate on applying the glue to the strip closer to the outside edge of the hull. When the strip is laid the glue should spread towards the inside when you lightly press on the strip.
Applying small amount of glue along the strip is possible using a toothpick or small applicator.
G.