• Win a Free Custom Engraved Brass Coin!!!
    As a way to introduce our brass coins to the community, we will raffle off a free coin during the month of August. Follow link ABOVE for instructions for entering.
  • SUBSCRIBE TO SHIPS IN SCALE TODAY!

    The beloved Ships in Scale Magazine is back and charting a new course for 2026!
    Discover new skills, new techniques, and new inspirations in every issue.

    NOTE THAT OUR NEXT ISSUE WILL BE MARCH/APRIL 2026

Planking : Clinker | Carvel | Deck | Waterway | PoF Plank on Frame | How to calculate, mark, build. + Jig + Nail ( nailing ), Bolt | by serikoff

Bob Ellis said:
I've searched for those dental cups but no luck.
Click to expand...


OOPS! I goofed!

See Kolobok's post #24 below. There is a variation of the plain cup burr style I originally referenced in this post which is called a "twin cut cup burr" which, with a flat cutting edge around the very end of the burr, cuts a flat rim around the half ball formed by the cup, producing a faux "peened shank and rove" as illustrated in Serikoff's posts explaining his method for making very realistic scale headed rivets and roves on clinker planks. If you want a faux "peened shank and rove," like Serikoff describes, get the "double cut cup burr" as Kolobok identified!

At the risk of sending Serikoff back to yank out some 1,800 rivets again as he admirably did before, I will note in passing for those who may be inclined to represent rivets on their models that it is important to verify the direction in which rivets are placed on your particular model. Copper rivets are made from flat-headed copper cut nails over the protruding points of which a rove is set. The protruding point and shank are then cut off a bit proud and this is then peened over the rove to set the rivet. It's customary in setting planking rivets in small boat lapstrake construction to drive the nails inboard, so that the heads of the nails end up on the outboard face of the plank, while the nail shank ends peened over the roves are on the inboard side of the planking. There may be a variation in this customary practice for reasons of which I'm unaware in the case of Alert and other various vessels.

********************************************************************************************************************************************************

Here you go:
www.temu.com

Temu

Shop Wire Rounding Bits at Temu. Make Temu your for fashion products. Shop trends.
www.temu.com
1774421692973.png
 
Last edited:
Ich habe ebenfalls nach dem Set geschaut, auch unter „Komet“, leider ohne Erfolg. Evt die Bestellnummer dazu posten (?)
Jetzt schon danke

Beziehen Sie auch ihre Fräser bei Temu?
 
Last edited:
use Cup Bur Twin Cut on Ebay or Google. Cut cups used in this topic, they have a cutting edge end can cut the bolt pattern as shown, working on the wire that is larger diameter than the burr itself. Regular burrs will round the edge of the wire only if burr is same or slightly larger than wire diameter .
 
Kolobok said:
Verwenden Sie Cup Bur Twin Cut (z. B. von eBay oder Google). Die in diesem Thema verwendeten Cup Bur Twin Cut haben eine Schneide, mit der sich das Lochmuster wie abgebildet ausschneiden lässt. Arbeiten Sie dabei an Drähten, deren Durchmesser größer als der des Fräsers ist. Herkömmliche Fräser runden die Drahtkante nur dann ab, wenn der Fräser den gleichen oder einen geringfügig größeren Durchmesser als der Drahtdurchmesser hat.
Click to expand...
Besten Dank
 
You must log in or register to reply here.
Back
Top