FALKONET LEUDO VINACCERI 1:48

TRIED TO START MY OWN LOG BUT DID SOMETHING WRONG ONE MORE POST HERE IF YOU DO NOT MIND HEINRICH, ANOTHE PROGRESS FIRST2 BULWORK PLANKS INSTALLE THIRD DRYING ONE MORE TO GO, TRIED USING THE SOLDERING IRON WITH PVA DID NOT WORK OUT USED JUST A DROP OF CA AT EACH BULWORK IT IS HOLDING WILL SEE HOW BAD IT IS WHEN I CUT THE JIG LOOSE. GOD BLESS STAY SAFE ALL DON
 

Attachments

  • 20210201_013645.jpg
    20210201_013645.jpg
    206.1 KB · Views: 13
  • 20210201_013754.jpg
    20210201_013754.jpg
    224.4 KB · Views: 13
HERE I AM AGAIN HEINRICH, OK PROGRESS THE 4 BULWORKK PLANKS INSTALLED ONE SIDE AND STARTING TO CUT OFF THE BUWORKS WHERE INSTRUCTIONS SHOW IT THE JIG DOES NOT SEEM TO LIFT OFF I HOPE WHEN I FINISH CUTTING IT WILL LIFT OFF OTHERWISE OH, OH. GOD BLESS STAY SAFE ALL DON
 

Attachments

  • 20210202_220618.jpg
    20210202_220618.jpg
    216.7 KB · Views: 16
  • 20210202_220703.jpg
    20210202_220703.jpg
    213.4 KB · Views: 17
  • 20210202_221423.jpg
    20210202_221423.jpg
    159.5 KB · Views: 16
@egen Dear Egen. Thank you so much for the beautiful pictures of the Leudo. This is an exquisitely finished model (I especially like the green, black and white hull). To be very honest, I built the model up to hull-completion stage to gain experience in the upside-down build format of Falkonet. When I finished the hull, my admiral expressed interest to carry on with the build. Maybe these pictures will inspire her! :)
 
Back
Top