HMS Thorn. Scratch build Swan class following the books written by David Antscherl and Greg Herbert

[Kevink]

Just the shutter plank to,go

 

[Kevink]

new addition to the shop. Smith little torch

 

[Kevink]

Its done. Whiskey plank installed.

 

[stuglo]

Don't you dare get sawdust into heaven's libation.
On the other hand, given the object of celebration and your location, wouldn't rum be more appropriate.
Congrogulations on excellent work

 

[Maarten]

Wonderfull work again. PS Do not drink the whiskey and light your new torch at the same time

 

[Kevink]

Its actually a bottle of Angostura’s finest rum, blended in 1999 formthe com-anies 175th anniversary. Its bottle #5 of 5

 

[Uwek]

Congratulations for reaching this status - Very good work !!

 

[stuglo]

Its actually a bottle of Angostura’s finest rum, blended in 1999 formthe com-anies 175th anniversary. Its bottle #5 of 5

My ignorance is again highlighted. Your work deserved the best.
Coincidently, my son introduced me to Plantation rum recently. A positive change from Scotland's holy tipple.

 

[Kevink]

 

[Hoss6262]

Congratulations Kevin! Such a great series of videos showing the rewards of planning and use of the universal language: Math!

 

[Tony P]

Great stuff Kevin. You're a wealth of knowledge.

 

[Kevink]

Error with the video ill repost

 

[Kevink]

 

[Tony P]

Dr Michael uses the needle method. The rotary tool is hand held though and not in the drill press. Time consuming but no more than other methods.

 

[Kevink]

 

[stuglo]

Avoid my mistake. Check thickness at top of ribs before completing inner and outer planking. Otherwise the planksheer will be too narrow.

 

[Kevink]

Just completed the last of the treenails

 

[Kevink]

Planning to start the rudder today

 

[Kevink]

An actual horseshoe clamp taken from the wreck of the HMS Janus. She sank in 1800 off Trinidad. This was given to me earlier this year by a commercial diver Robert Stauble who knew of my interest in out marine history. Notice how rough the casting is. Makes one wonder if it ws recessed or just bolted flat against the keel and the hull. Its 33 1/4“ wide, 22” high, the width of the cast is 3 1/2” and its 3/4” thick. The holes are 1 1/2” wide and there are 7 holes to take the bronze pins.

 

[Donnie]

Absolutely Stunning. From time to time, I do tune into your youtube channel. I have learned a lot from your videos. Thank you for sharing.