Wow - Your rigging is looking very good - very good eye for the correct details
Your masting and rigging follows the quality of your wooden work
Your masting and rigging follows the quality of your wooden work
-
LUCZORAMA SHIPWRECK SCAVENGER HUNT GIVEAWAY. 4 Weeks of Fun • 1 Legendary Prize ((OcCre’s Fram Ship)) • Global Crew Welcome!
**VIEW THREAD HERE**
“La Jacinthe” Schooner France -1:42 scale [COMPLETED BUILD]
Thank you very much dear friends
for such a high evaluation of my work.
My best regards.
for such a high evaluation of my work.
My best regards.
Now I understand the captain who loses the mast on the final stage of the regatta. Probably every modelist faces this kind of fail.
Its good that I have made the topmast dismountable, just like on a real schooner. I haven't had any problems with the dismantlement.
The knot has been disassembled.
The knot has been disassembled.
Seems that you had too much m2 sail out during strong wind ....... captain is responsible
My hand had accidentaly got caught on the assembled fore-tompast stay. The outrigger remained in place , but the topmast didn't...
I made a device for the axial drilling. I’ve managed to maintain a coaxial alignment. A pin is made from a nail. 
After consideration, I decided to glue using PVA glue. For several reasons - cyanoacrylate glue, even gel, binds very fastly, and I was afraid that the pin will be fastened sooner than it enters fully, on its full depth. The second reason is that once the cyanoacrylate glue is binded is gets very fragile and the junction may crack even at a slight bend. PVA glue is more flexible even after drying, and if there are few gashes on the pin it will hold tightly and more so as the binding time is long enough it allows to put the piece right in place. There’s only one thing bothering me - how much time does it take to bind inside the wood? Perhaps it would be better if i heat up the place where the pin is set?
I have gone back to square one. 
Hi Aleksandr, I am using the same technique (metal pin between wood) for all my mast\spars bowsprit. I also use PVA as the main glue but...I use CA as the vise: i put few drops just on the ends and once I press everything together CA holds and act as the vise\clamp.
Dear KNUT. I'm very glad if i could help.
While working on the installation of riggings, I made the flag and pennant.
Taking my wife’s advice I bought a rayon of three different colors, instead of using the dye, luckily it’s not the British flag, so I glued the rayons together, just like the sails.
I made it in two variations.
Taking my wife’s advice I bought a rayon of three different colors, instead of using the dye, luckily it’s not the British flag, so I glued the rayons together, just like the sails.
I made it in two variations.
The flag is looking very realistic
Thank you for sharing your construction process wih us
