Mike, I am thrilled by your job on the framing! Very accurate and precise! 
I cannot wait to get my hands on POF build.
I cannot wait to get my hands on POF build.
CAF Models La Salamandre...1:48 My Attempt
- Thread starter BigMike
- Start date
- Watchers 37
-
- Tags
- caf model la salamandre
+1Mike, I am thrilled by your job on the framing! Very accurate and precise!
Thanks a lot Jim. You are going to love building POF. I cannot wait to see what you do with Alert.Mike, I am thrilled by your job on the framing! Very accurate and precise!
Yea...I cannot wait for the moment to see it landed near my door (in my hands)
You might need help... It gonna be HEAVY....
Own burden does not pull !!!You might need help... It gonna be HEAVY....
- Joined
- Jan 9, 2020
- Messages
- 10,462
- Points
- 938
That's the problem with BigMike's builds. He whets the appetite for everything he does! I am also getting more and more intrigued by POF. problem is just that there aren't that many kits around (other than the usual suspects) and I'm not yet ready for a scratch-build.
I am also getting more and more intrigued by POF. problem is just that there aren't that many kits around (other than the usual suspects) and I'm not yet ready for a scratch-build.
Well here is what’s been going on in the shop this week. I finally found that elusive last frame after 2 months. I sanded the inside of the hull to about 90% done. Installing 3 frames at a time and the fairing them close to the line worked well. The keelson fit in the notches with a little adjusting. There are a few frames on the outside of the hull that need some attention but final fairing should take care of that.
Next it was on to the stern. Glued up the 7 timbers and cut the opening for the stern post and the helm port.
Quarter timbers roughed out and will be shaped during fairing.
Hope to get model out of building jig and start on the hawse pieces.
Next it was on to the stern. Glued up the 7 timbers and cut the opening for the stern post and the helm port.
Quarter timbers roughed out and will be shaped during fairing.
Hope to get model out of building jig and start on the hawse pieces.
I can just echo what Mike said! Fantastic and very accurate!!! 
I will have lots of questions when start building an Alert.
I will have lots of questions when start building an Alert.
Yes sir thats lookin awesome man !!!
Thanks Mike
Thanks JimI can just echo what Mike said! Fantastic and very accurate!!!
Thanks Clair appreciate it.
Thanks Daniel, it’s been a lot of fun so far.
