Hello moi je les ai pas faites tout simplement
Le Rochefort 1/36 - Build Log by Moreplovac
- Thread starter moreplovac
- Start date
- Watchers 25
-
- Tags
- ancre group build le rochefort
Good morning, as Titoneri has already written, just leave it out. I didn't do it either, it just caused me problems with La Palme. As for the second question here, I have to admit that I don't really understand what you mean.
Thank you...
Well, in that cones, one more completed..
Happy modelling..
Happy modelling..
, I think Dieter has determined the angle, I think it was around 60 degrees. If you want to mill it, you can use your vice from the MF70, here you can prepare at 45 degrees and sand or scratch off the rest. 
Thank you..
View attachment 452291
I used my mill. I set the head angle and made a little backstop to support the keel and milled the rabbit in sections.
A bit of a progress,,, magenta keel part was turned around for no apparent reason 
Happy modelling..
Happy modelling..
You're making good progress and it looks very clean
Thanks,
It took me few attempts to get a grip on a tools but should be better now....
Don't have much of a time to dedicate to build but getting there slowly..
A little table addition to bridge the gap between sanding paper and sanded part... just a two piece of plexiglass, glued together for thickness and two holes matching diameter of a sanding cylinder.. suction action of an attached vacuum, keeps the plexiglass very tight...
On the bench.... during action...
All parts are almost done...
Hard to find some hobby time during Euro24...
Happy modelling..
On the bench.... during action...
All parts are almost done...
Hard to find some hobby time during Euro24...
Happy modelling..
A bit more work done today...
The ruler provides close to required angle but still some work by hands needs to be done to make sure all fits nicely...
A bit more filling is required...
Happy modelling..
The ruler provides close to required angle but still some work by hands needs to be done to make sure all fits nicely...
A bit more filling is required...
Happy modelling..
Looking good
Ok, after few weeks holidays, I am back on line and behind the mill.... will continue with build after I finish washing my car, after 8000km....
Happy modelling..
Happy modelling..
The build continues with assembling few parts, including keel...
It appears to ended up OK. still some sanding is needed..
Also, I have cut the angle on the keel with a knife, file and sanding so will see end results..
Keel parts were glued together but was noted some curving on the keel so had to reassemble and glue them again with mora usage of wise and heavy objects..
End both parts...
Happy modelling...
It appears to ended up OK. still some sanding is needed..
Also, I have cut the angle on the keel with a knife, file and sanding so will see end results..
Keel parts were glued together but was noted some curving on the keel so had to reassemble and glue them again with mora usage of wise and heavy objects..
End both parts...
Happy modelling...
Managed to get the keel straight...
Now we can continue...
Happy modelling..
Now we can continue...
Happy modelling..
A bit more progress..
Very nice result, the base looks very good.
Work continues with
must admit it takes some mental strength to continue with work on this project... just small pace results comparing to a kit model... by now I will most likely finish the hull...
Happy modelling...
Thank you Tobias,
must admit it takes some mental strength to continue with work on this project... just small pace results comparing to a kit model... by now I will most likely finish the hull...
Happy modelling...