Hi Oliver, I can understand you and Paul perfectly. It didn't work out particularly well for me either. Therefore, I'd say you did everything right.
-
Win a Free Custom Engraved Brass Coin!!!
As a way to introduce our brass coins to the community, we will raffle off a free coin during the month of August. Follow link ABOVE for instructions for entering. -
PRE-ORDER SHIPS IN SCALE TODAY!
The beloved Ships in Scale Magazine is back and charting a new course for 2026!
Discover new skills, new techniques, and new inspirations in every issue.
NOTE THAT OUR FIRST ISSUE WILL BE JAN/FEB 2026
Le Rochefort build log by OlivierF
- Thread starter OlivierF
- Start date
- Watchers 39
-
- Tags
- ancre group build le rochefort
Admire your willingness to rip out and do over! They look great.
Thanks for sharing photos and progress on you build!
Thanks for sharing photos and progress on you build!
I completed the main deck beams 
I also made the mast wedges and shellacked them. They’ll be put aside until needed.
Now I need to determine next steps. Do I make the waterways and inner wales or do I start on planking the hull?
Decisions, decisions…
Maybe I’ll have a beer and think about it.
Cheers all!
I also made the mast wedges and shellacked them. They’ll be put aside until needed.
Now I need to determine next steps. Do I make the waterways and inner wales or do I start on planking the hull?
Decisions, decisions…
Maybe I’ll have a beer and think about it.
Cheers all!
Congratulations, Oliver. A nice accomplishment (the beams - not the beer 
).
).
I decided to complete the waterways and the inner bulwarks. I needed to figure out a way to mill a 30° angle on the waterways. I said, “self, simple is always better.” So, I tilted my Proxxon FET saw to 30° and tried to rip the strips. Complete and absolute failure! 
Next, I cut a 30° piece on my full size table saw and double stick taped it to my mini mill and then CA glued a fence to that piece.
This allowed me to use the mill like a router and feed the strips through this fence assembly.
I took multiple small passes so the wood wouldn’t chatter and try to kickback.
Success!
I’ll take a sanding block and smooth them out a bit but otherwise I’m happy.
Now on to the next step…
Cheers everyone!
Next, I cut a 30° piece on my full size table saw and double stick taped it to my mini mill and then CA glued a fence to that piece.
This allowed me to use the mill like a router and feed the strips through this fence assembly.
I took multiple small passes so the wood wouldn’t chatter and try to kickback.
Success!
I’ll take a sanding block and smooth them out a bit but otherwise I’m happy.
Now on to the next step…
Cheers everyone!
Clever...
I agree! Especially now that I upgraded to an ER-11 collet.
That's a good idea, I agree. Just one small point: make sure you don't have a 90-degree angle to the bulwark at the back. I hope you can bend the straight strips well. I cut mine from a board and shaped and fitted them by hand.
Thanks for the tip Tobias. I do plan to cut the waterways as you mention for the curved section of the bow.
Merry Christmas to you and yours!
Merry Christmas to you and yours!
Merry Christmas to you and your family as well.
