ZHL San Felipe 1690 - Ted R

[Treenailmooter]

Ted, did you just reshape the support piece or make a new one from scrape wood?

 

[Ted Robinson]

Completed filling in dummy cannon blocks on the starboard side.

 

[Ted Robinson]

Completed dummy cannon blocks.
Now on to getting the stern platforms installed.

 

[Ted Robinson]

Installed between deck bulkheads 7-11.
Painted recessed dummy cannon blocks.
The ink passed the smudge test perfectly.

 

[Ted Robinson]

By the way, using ink vs paint could leave your fingers stained.lol

 

[Ted Robinson]

Between deck bulkheads 7-10 are perfectly level, however #11 is lower.
I don't know if this is a problem.

 

[Peter Voogt]

The only significant project I have completed was the Bluenose also from ZHL.

The Bluenose was from YuanQing. And when I see the cover of the box in your post #1 this one is also from YuanQing. I suppose you bought it via ZHL?
But so far a interesting build, Ted.
Regards, Peter

 

[Ted Robinson]

The Bluenose was from YuanQing. And when I see the cover of the box in your post #1 this one is also from YuanQing. I suppose you bought it via ZHL?
But so far a interesting build, Ted.
Regards, Peter

Yes it was Yuanquing. Senior moment

 

[Ted Robinson]

I've been trying to get what appears to be correct alignment on the three deck platforms at the stern for a few hours. I can't get them all aligned due to interference with the dummy cannon blocks. I've decided to abandon the cannons at the stern and build closed cannon ports.

 

[Ted Robinson]

Here is what I have after the modification.

 

[Dematosdg]

By the way, using ink vs paint could leave your fingers stained.lolView attachment 553356

HAHAHA.... Pass the ink, it will soak in the wood and use a piece of cotton fabric to clean the excess. Job is looking very well.

 

[Dematosdg]

By the way, using ink vs paint could leave your fingers stained.lolView attachment 553356

BTW, when you use the black ink for imitating ebony, the positive side is that it enter the wood more deeply than paint. If you then scratch that piece of wood, the scratch will not be noticeable as if you scratch a painted wood.

Cheers !!!
Daniel

 

[Dematosdg]

Sorry...repited post... deleted !!

 

[Dematosdg]

Between deck bulkheads 7-10 are perfectly level, however #11 is lower.
I don't know if this is a problem.View attachment 553357View attachment 553358

Check the plans and drawings. Could it be that the deck is lower on that section ?

 

[Ted Robinson]

That's as life as it can go.

 

[Ted Robinson]

Glued frame 12 in place.
Install four parts 16 and platform 51 in place to locate we them. I'll glue part 51 when they are dry.
Btw, I reinstalled the aft dummy cannon blocks lower than where they were.
It's a crapshoot if they will work. Yo 11.

 

[Ted Robinson]

BTW, when you use the black ink for imitating ebony, the positive side is that it enter the wood more deeply than paint. If you then scratch that piece of wood, the scratch will not be noticeable as if you scratch a painted wood.

Cheers !!!
Daniel

Thank you again for this kit. I'm having a great time building it. You should reconsider and get you one again.