Being able to close the chapter 'Cabin'.
In particular, my decision to make the roof removable took a lot of creativity time.
This is what the 'closed side' now looks like:
4 eyebolts with ring on the front with which at least 1 oil drum is later secured.
The chimney is the version YQ provides with the kit. The Saga and Eisnor show the same. MS shows a flat laid pipe, which can also be seen in the old photo shown earlier. I went for this pipe anyway.
On either side of the deck a wide plank across the entire side.
Here MS is clear again with the text: "A solid handrail optional, since not seen in all photos. Perhaps by Racing. Another option: wide board along entire edge, used for cutting bait while fishing." I make my BN in fishing version, so with the planks.
Seen obliquely from the rear:
And:
with open sky light, sliding cover and doors.
To show enthusiasts the interior better, the roof can be removed:
With the problem mentioned above: Part of the side walls to which the doors are attached.
I had 2 options:
1: put the side walls on the walls of the stairwell, but then the sliders of the sliding cover started to float;
2: divide the side walls at the height of the roof, but then the doors were only fixed with the bottom hinges.
It eventually became option 2. Why choose the easiest way ........ On reflection: I could also have cut them diagonally from 'high back' to 'low front'.
The bare wood of the inside is coated with linseed oil. This accentuates the moldings on the walls again.
The trim at the top has a gap on the starboard side and partly at the rear. That's right. The planking on the outside has not been installed there and the molding runs around the 1/4 round corner posts that also protrude slightly on the open side.
The view into the cab from the other side:
I had already made the interior. Only 3 light bulbs hung. Not as bright as the led's like Johan
@RDN1954 of Lawrence
@Canoe21 
...........
Gr. Peter
